How to find POE/IP camera's Version Information?
If you use the camera alone, power on the camera with 12v power adapter and then connect it to router by network cable.
1.1 Download CMS to your pc (make sure the camera and pc in the same local network)and install it on your pc. Run it.
1.2 Refer to Download CMS and Add Device to CMS:
When you search the camera's ip, find the ip address like: 192.168.0.XX or similar to that.
1.3 After you add this camera to CMS, you can find its version information here: move your mouse on the camera and then right click - device config - version

7 Comments
Hello, please send a link to the latest version of the 8-channel NVR firmware. My current version is: V4.03.R11.C6380208.12201.040000.0000000
Thx
What should I do? do a software update? Should I send a picture of the software version?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?