How to find POE/IP camera's Version Information?
11 May 2023
7件のコメント
If you are using the camera alone, power it on with a 12V power adapter, and then connect it to the router using a network cable.
1.1 Download CMS to your PC (ensure the camera and PC are on the same local network) and install it. Run the CMS application.
1.2 Refer to Download CMS and Add Device to CMS:
When searching for the camera's IP, locate the IP address such as 192.168.0.XX or similar.
1.3 After adding the camera to CMS, find its version information: hover your mouse over the camera, right-click - device config - version
タグ:
7件のコメント
Hello, please send a link to the latest version of the 8-channel NVR firmware. My current version is: V4.03.R11.C6380208.12201.040000.0000000
Thx
What should I do? do a software update? Should I send a picture of the software version?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?
Hi, I have a Techage H.256 1080p PoE system. The NVR cannot boot up with only System Initializing and keep reboot. I cannot get to the firmware to check what is the version. The motherboard is HI3536D_V120_NVR040816 2017/12/15. Can you send me the firmware for this NVR?