HDD not found / HDD information and format it
25 Apr 2023
11件のコメント
Please refer to these below to solve the HDD not found issue.
1.If hard drive was preinstalled, there are 4 screws at the bottom of NVR box.
2. Check the power adapter to confirm if it has enough power or not.
Notice : The WiFi NVR (8208,8204,9604,9608,8508,8708) should use 12V 2.5A power supply.
PoE NVR (6708FN,6708KR,6708K)should use 52V2.5A power adapter.
3.Please open the NVR with a screwdriver, check the two cables connecting the hard drive and see if they are loose.
4.Take the hard disk out and install it on your computer. Check if the computer can recognize the hard disk.
Check Hard Drive Information on NVR box and Format it
Right click the mouse>system setup>General setup>HDD setup>select the hard disk>Click Format
タグ:
11件のコメント
I have a purchased a NVR POE 4channels and i have conected to NVR I have installed an 1TB hard drive and the drive is not recognized, the drive is suitable for this task even is formatted in NTFS with no partitions but it can’t be read, instead I have installed an old drive with 80Gb the two drives manufactured by Seagate and this is recognized and promt to format the drive and is done and can save the videos but I can make it to the big drive I have mounted both in my pc and both are usable I can write/delete files.
Meanwhile I will try with the 80Gb drive an set the cameras to lower quality to avoid data overwritting, waiting for a fix for this from you, or maybe is a firmware update to do in the NVR.