1. You can find the reset button near the SD Card Slot or RJ45 Lan cable. 2. Long press the reset button about 10 seconds. 3. Make sure you can hear the reset configuration sound, then all setting and password will restored. Default user name is admin, password is blank.

When it comes to setting up a surveillance system, choosing the right hard drive is crucial. Surveillance systems continuously record and store high-definition video footage, requiring a hard drive that can handle the demanding workload. In this section, we will discuss the key requirements to consider when selecting a hard drive for your surveillance...

1. Check whether all your cables are connected well. 2. Connect your NVR to internet. 3. Download CMS software and add your NVR to CMS 4. Right click the IP of NVR---choose Device Config---choose gui display---choose the lowest resolution---ok (reason: the resolution of your monitor is lower than NVR) if you even can not search the...

1. Please download H265General_ VDiskPlay tool 2. Insert your USB card reader into USB port of your PC (if it pops out a message by saying format disk, then cancel it) 3. Unzip and Install H265General_ VDiskPlay and open VDiskPlay, choose date---channel---video, then you can view video.    

If you are using the camera alone, power it on with a 12V power adapter, and then connect it to the router using a network cable. 1.1 Download CMS to your PC (ensure the camera and PC are on the same local network) and install it. Run the CMS application. 1.2 Refer to Download...